Skip To Content

Best Auto Repair, Houston

12510 Oxford Park Drive Houston, TX 77082

281-589-8984
Opening Hours
  • Mon 8:00AM - 6:00PM
  • Tue 8:00AM - 6:00PM
  • Wed 8:00AM - 6:00PM
  • Thu 8:00AM - 6:00PM
  • Fri 8:00AM - 6:00PM
  • Sat Closed
  • Sun Closed
CONTACT US

Using Proper Fluids in Your vehicle

Posted December 30, 2019 11:39 AM


Today, Westside Automotive is writing about the proper fluids for your vehicle. It's become more complicated with changes in automotive design and manufacturing. It's not that people in Houston are confused as much as they don't realize how much things have changed in recent years.

If you have questions about the fluids in your vehicle, please don't hesitate to stop by Westside Automotive. You can find us on 12510 Oxford Park Dr. in Houston, TX 77082.
Just give us a call at 281-589-8984.

Let's take engine oil. Twenty or 30 years ago, there were just a handful of different weights of oil. The weight of an oil is a scientific measure of its properties, particularly its viscosity or thickness.

It was common in those days to use a lighter weight oil in the winter when it's cold outside. That way the oil would be able to splash around inside the engine and protect the parts before it was fully warmed up. And a heavier weight oil would be used in the summer. The thicker oil wouldn't thin out too much in the summer heat and vaporize in the engine.

Modern valve trains have become very complicated with more moving parts and small passages than ever before. The valve train is in the top of the engine, so when the vehicle has been turned off for a while, the oil tends to run down to lower areas.  That means the valve train parts are vulnerable at start-up, before the oil starts circulating.

So new weights of oil have been introduced to meet the engineering specifications of these newer engines.

Manufacturers are recommending specific weights of oil. The recommendation is often printed on the oil fill cap. It's certainly in the owner's manual. Of course, Westside Automotive in Houston can look it up for you.

It's more important than ever to have the correct weight of oil. The wrong weight could actually harm the engine.

Other fluids are also becoming more sophisticated. In the last few years new types of transmission, power brake fluid and coolant have all been introduced for some of the same reasons as for engine oil.

In addition, vehicle manufacturers are now using a wider variety of materials in these systems. Looking at the cooling system as an example, it used to be that the parts were all made out of steel or iron and the hoses were rubber. Now, some parts are plastic, aluminum or other materials.

So the anti-corrosion additives contained in the coolant, or anti-freeze, need to be different in order to protect the different materials used to make the cooling system. If you use the wrong coolant that wasn't formulated to protect your plastic cooling system parts, they could become corroded and fail. And if you're using the wrong coolant, your cooling system won't be covered under warranty. So it's important to use the right coolant and to not mix different types.

Your owner's manual or service advisor at Westside Automotive can make sure you're using the right type. You may have heard of universal coolant. Universal, or global, coolant can be added to other types without harmful reactions. That's OK for an emergency top off, but following your manufacturer's recommendation for your vehicle or other auto type is always a safe bet.

In the area of brake fluid, there are a couple of new formulations. It's important to remember that the new ones aren't better than the old ones. They're just different formulations for different vehicles. So if your vehicle calls for DOT 3, using DOT 4 or DOT 5 is not an upgrade. Use the recommended formula.

There are fluid formulations for vehicles with higher mileage. These are special engine oil, transmission fluid and so on that contain additives to condition and restore seals and gaskets in older engines.

They're fine to use as long as they're a variant of the proper fluid. In other words you can use a high mileage engine oil as long as it's also the correct weight recommended by the manufacturer. Same goes for transmission fluid; as long as it's the right type for your transmission.

Westside Automotive
12510 Oxford Park Dr.
Houston, TX 77082
281-589-8984
http://www.houstonwestsideautomotive.com

 



Search



Archive

December 2019 (15)
January 2020 (5)
February 2020 (4)
March 2020 (5)
April 2020 (4)
May 2020 (5)
June 2020 (4)
July 2020 (4)
August 2020 (5)
September 2020 (4)
October 2020 (4)
November 2020 (5)
December 2020 (4)
January 2021 (6)
February 2021 (4)
March 2021 (4)
April 2021 (4)
May 2021 (5)
June 2021 (4)
July 2021 (4)
August 2021 (5)
September 2021 (4)
October 2021 (5)
November 2021 (4)

Categories

Air Conditioning (3)Alignment (1)Alternator (1)Auto Safety (2)Automotive News (3)Battery (3)Brakes (7)Cooling System (3)Dashboard (1)Diagnostics (1)Diesel Maintenance (1)Differential Service (1)Drive Train (2)Exhaust (1)Fluids (3)Fuel Economy (2)Fuel System (12)Maintenance (14)Oil Change (1)Older Vehicles (2)Parts (2)Safety (1)Service Intervals (2)Service Standards (4)Shocks & Struts (2)Steering (3)Timing Belt (4)Tires (1)Tires and Wheels (12)Transmission (4)What Customers Should Know (14)Windshield Wipers (3)
  • AAA (American Automobile Association)
  • ASE (Automotive Service Excellence)
  • Jasper
  • ASE Master Technician
  • Bosch Service
  • BG Products
  • Denso
  • Car Care Aware

Testimonials

Great service, honest business and fair pricing. I have been taking my vehicles here for years and have always been very satisfied.
view all reviews
TAP TO CALL NOW 281-589-8984 X